Use POSIX syntax, write the question like a typical y/n prompt.

Bobby The Builder authored 3 years ago and Oliver Smith committed 3 years ago

skip delay when updating automatically

Bobby The Builder authored 3 years ago and Oliver Smith committed 3 years ago

* Prevent interactive warning to pop once already approved when
  [over/down]clocking DRAM
* Make sure $freq is always set

Co-Authored-By: Oliver Smith <ollieparanoid@postmarketos.org>

Bobby The Builder authored 3 years ago and Oliver Smith committed 3 years ago

Switched to crust repo:
  https://github.com/crust-firmware/arm-trusted-firmware/releases

In 35f283a8 sxmo was made to install
sxmo on clean installs, but due to
9387842a was getting uninstalled if it
was installed before. Let's properly depend on it instead so people
don't end up without working networking

Gummiboot was dropped from Alpine. Switch to grub, which is what we use
for tablet-x86uefi too.

In contrary to tablet-x86uefi, run the grub-mkimage command directly
inside the device package:
* This avoids creating another confusing grub-x86 like package (looks
  like the x86 version of alpine's grub package, as it's the case with
  grub-efi-x86, but actually it is just the result of grub-mkimage).
* In contrary to grub-efi-x86, the resulting efi file is not shared
  across several devices.
* It's consistent with uboot mkimage commands, which we also run in
  device packages.

Related: https://gitlab.alpinelinux.org/alpine/aports/-/commit/398b7aef0b86c477103ba592526ebb9940a44509

This makes sure mce doesn't just lock the session after a few seconds
and is then unable to unlock it

This makes sure mce doesn't just lock the session after a few seconds
and is then unable to unlock it

[ci:ignore-count] Only small packages are changed, should be quick to
build

The Mer stack that Asteroid uses actually uses connman by default rather
than NetworkManager, so let's enable it by default

SSH still works at least on Qemu

The Mer stack that Glacier uses actually uses connman by default rather
than NetworkManager, so let's enable it by default

SSH still works at least on Qemu

The actual dependency is already pulled in via plasma-nm-mobile

Yassine Oudjana authored 3 years ago and Oliver Smith committed 3 years ago

The v5.12.5-msm8996 tag also includes the yet-to-be-merged Qualcomm LPG
driver, with support for LEDs on xiaomi-scorpio including the IR LED.

Also clean up the config and enable useful configs such as ZRAM.

[ci:skip-build]: already built successfully in CI

Caleb Connolly authored 3 years ago and Dylan Van Assche committed 3 years ago

We've rename the kernel repo to
https://gitlab.com/sdm845-mainline/linux,
update the package to point to the new repo.

[ci:skip-build]: already built successfully in CI

Oliver Smith authored 3 years ago and Dylan Van Assche committed 3 years ago

We used to have it at 40% and just bumped it to 100%. With 100%, I can
hear static noise in the headphones when using the PinePhone (pmOS CE)
in a silent room, even if I turn the volume down in Pulseaudio (e.g.
18%-30% in Phosh). This was not the case when we had it at 40%.

70% seems to be the sweet spot, where no static noise can be heard when
using headphones in a silent room, but where volume can still be turned
up to a very high level if necessary.